From day-to-day workshop equipment, through to custom built fluid transfer and management systems – our ability, technical knowledge and focus on supplying and applying the very best solution for our customers are at the forefront of everything we do.
Step 1 Contact
Contact our team through this website, email or by phone. We’ll discuss with you your fluid needs and conduct a pre-visit assessment. Our team can start to provide some indicative costs to give you a general idea before we visit.
Step 2 Onsite Assessment
The next stage may involve our team visiting your site to review your workshop area and operation, and talking to your team about your requirements. We’ll make some recommendations based on our experience in this industry and then take some dimensions and photos that help us in our design later. We’re also there to answer any questions you may have.
Step 3 Design A System
Contact our team through this website, email or by phone. We’ll discuss with you your fluid needs and conduct a pre-visit assessment. Our team can start to provide some indicative costs to give you a general idea before we visit.
Step 4 Install
Our team comes on site and carries out the installation, which depending on the complexity and size of the project, may take up to several weeks to complete. We will brief your team before we start, especially those who are involved in the installation.
Step 5 Ongoing Support
Once your system is up and running, we’ll provide your team with training to get the most from it. That’s not the end though - our team will regularly check in to make sure the system is functioning as expected. We’re also your equipment provider, with access to some of the industry’s best workshop equipment.
OUR CLIENTS
Trusted by Industry Leaders
Choosing a selection results in a full page refresh.